热处理对U76CrRE稀土重轨钢夹杂物和微观组织的影响

doi:10.13251/j.issn.0254-6051.2022.08.034

摘要/Abstract

摘要： 选取U76CrRE钢坯进行1100、1200、1300 ℃分别保温1、2、3 h的热处理,使用FEI-QUANTA400型扫描电镜对夹杂物进行了观察,利用Axiovert型蔡司光学显微镜对微观组织进行观察,使用Qness-Q10A+全自动显微硬度计进行硬度测试。结果表明,热处理对U76CrRE稀土重轨钢中夹杂物的作用明显,使夹杂物形状与尺寸都有明显改善,随着加热温度的升高,可以进一步优化MnS和复合夹杂物的形貌和尺寸。在1100 ℃加热时,MnS与复合夹杂物尺寸随着保温时间的增加而减小,形状得到明显改善;在1200 ℃加热时,随着保温时间的增加,MnS尺寸减小,复合夹杂尺寸变大。U76CrRE稀土重轨钢的晶粒随着加热温度的升高明显增大,硬度呈现先减后增的趋势,随着保温时间的增加逐渐减小。在1100 ℃加热时,试验钢中组织皆为马氏体、贝氏体和残留奥氏体,且晶界均不明显;在1200 ℃与1300 ℃保温超过1 h后,试验钢中网状渗碳体明显;在1300 ℃保温1 h时,晶界积碳严重,碳化物未得到有效溶解。在1200 ℃保温1 h时,试验钢中晶粒均匀,晶界明显,组织主要为残留奥氏体与珠光体,组织均匀。

关键词: U76CrRE稀土重轨钢, 淬火温度, 保温时间, 夹杂物, 微观组织, 硬度

Abstract: U76CrRE billets were heat treated at 1100 ℃, 1200 ℃ and 1300 ℃ for 1 h, 2 h and 3 h, respectively. The inclusions were observed by FEI-QUANTA400 scanning electron microscope, the microstructure and hardness were observed and tested by means of Axiovert Zeiss optical microscope and Qness-Q10A+automatic microhardness tester. The results show that the heat treatment has obvious effect on the inclusions in the U76CrRE rare earth heavy rail steel, and the shape and size of inclusions are significantly improved. With the increase of heating temperature, the morphology and size of MnS and compound inclusions can be further optimized. When heated at 1100 ℃, the size of MnS and compound inclusions decreases with the increase of holding time, and the shape is obviously improved. When heated at 1200 ℃, the size of MnS decreases and the size of compound inclusions increases with the increase of holding time. The grain size of the U76CrRE rare earth heavy rail steel increases obviously with the increase of heating temperature, and the hardness shows a trend of first decreasing and then increasing, while decreases gradually with the extension of holding time. When heated at 1100 ℃, the microstructure of the tested steel is martensite, bainite and retained austenite, and the grain boundary is not obvious. After holding at 1200 ℃ and 1300 ℃ for more than 1 h, the network cementite in the tested steel is obvious. When heat treated at 1300 ℃ for 1 h, the carbon deposition at the grain boundary is serious and the carbides are not effectively dissolved. When held at 1200 ℃ for 1 h, the grains of the tested steel are uniform, the grain boundaries are obvious, the microstructure is mainly retained austenite and pearlite, and the microstructure is uniform.

Key words: U76CrRE rare earth heavy rail steel, quenching temperature, holding time, inclusion, microstructure, hardness

中图分类号:

TG156.1

李向川, 杨吉春, 白国君, 樊志明. 热处理对U76CrRE稀土重轨钢夹杂物和微观组织的影响[J]. 金属热处理, 2022, 47(8): 200-210.

Li Xiangchuan, Yang Jichun, Bai Guojun, Fan Zhiming. Effect of heat treatment on inclusions and microstructure of U76CrRE rare earth heavy rail steel[J]. Heat Treatment of Metals, 2022, 47(8): 200-210.

参考文献

[1]张智, 任新建, 魏仁群, 等. U76CrRE稀土钢轨性能研究[J]. 稀土, 2009, 30(1): 62-66.
Zhang Zhi, Ren Xinjie, Wei Renqun, et al. Study on properties of U76CrRE rare earth rail[J]. Chinese Rare Earths, 2009, 30(1): 62-66.
[2]Wang X L, Song B, Li Y B, et al. Corrosion behaviors of U75V, U76CrRE heavy rail steel in simulated industrial atmosphere[J]. Applied Mechanics and Materials, 2013, 2755: 2031-2037.
[3]张智, 洪海峰, 智建国, 等. U76CrRE钢轨的热处理[J]. 金属热处理, 2010, 35(3): 119-121.
Zhang Zhi, Hong Haifeng, Zhi Jianguo, et al. Heat treatment of U76CrRE rail[J]. Heat Treatment of Metals, 2010, 35(3): 119-121.
[4]王立新, 李智丽, 王嘉伟, 等. U76CrRE稀土钢轨连续冷却曲线和组织性能研究[J]. 稀土, 2017, 38(1): 85-89.
Wang Lixin, Li Zhili, Wang Jiawei, et al. Study on continuous cooling curve, microstructure and properties of U76CrRE rare earth rail[J]. Chinese Rare Earths, 2017, 38(1): 85-89.
[5]徐国军, 胡华东, 田川, 等. Al₂O₃夹杂在DC06钢中的分布及对深冲性能的影响[J]. 中国冶金, 2021, 31(5): 111-117.
Xu Guojun, Hu Huadong, Tian Chuan, et al. Distribution of Al₂O₃ inclusions in DC06 steel and its effect on deep drawing properties[J]. China Metallurgy, 2021, 31(5): 111-117.
[6]齐江华, 杨成威, 朱万军, 等. 加热保温处理对重轨钢中MnS夹杂的影响[J]. 钢铁, 2013, 48(11): 79-83.
Qi Jianghua, Yang Chengwei, Zhu Wanjun, et al. Effect of heat preservation treatment on MnS inclusion in heavy rail steel[J]. Iron and Steel, 2013, 48(11): 79-83.
[7]鲁达, 李维福, 任英, 等. 固态钢加热过程中非金属夹杂物转变研究进展[J]. 钢铁研究学报, 2020, 32(12): 1021-1028.
Lu Da, Li Weifu, Ren Ying, et al. Researchprogress on transformation of non-metallic inclusions in solid steel during heating[J]. Journal of Iron and Steel Research, 2020, 32(12): 1021-1028.
[8]林腾昌, 门兵, 程雄, 等. 热处理对铸态钢中硫化锰夹杂物的影响[J]. 中国冶金, 2021, 31(4): 48-54.
Lin Tengchang, Men Bing, Cheng Xiong, et al. Effect of heat treatment on manganese sulfide inclusion in as cast steel[J]. China Metallurgy, 2021, 31(4): 48-54.
[9]战东平, 杨永坤, 姜周华, 等. 加热过程钢中夹杂物演变的研究进展[J]. 钢铁, 2021, 56(10): 1-14.
Zhan Dongping, Yang Yongkun, Jiang Zhouhua, et al. Research progress of inclusions evolution in steel during heating[J]. Iron and Steel, 2021, 56(10): 1-14.
[10]潘权文, 颜莹, 李小武, 等. 热处理对双真空冶炼AISI 4340钢显微组织和拉伸性能的影响[J]. 材料热处理学报, 2021, 42(4): 87-95.
Pan Quanwen, Yan Ying, Li Xiaowu, et al. Effect of heat treatment onmicrostructure and tensile properties of AISI 4340 steel produced in double vacuum[J]. Transactions of Materials and Heat Treatment, 2021, 42(4): 87-95.
[11]王皓, 包燕平, 智建国, 等. 稀土Ce对含磷高强IF钢铸轧全过程MnS夹杂物影响[J]. 工程科学学报, 2020, 42(S1): 1-8.
Wang Hao, Bao Yanping, Zhi Jianguo, et al. Effect of rare earth Ce on MnS inclusions in high strength if steel containing phosphorus during casting and rolling[J]. Chinese Journal of Engineering, 2020, 42(S1): 1-8.
[12]沈昶, 郑福舟, 陈洁, 等. 钢中Al₂O₃夹杂物生成、聚集原位观察[J]. 钢铁钒钛, 2020, 41(3): 128-131, 142.
Shen Chang, Zheng Fuzhou, Chen Jie, et al. In-situ observation on the formation and aggregation of Al₂O₃ inclusions in molten steel[J]. Iron Steel Vanadium Titanium, 2020, 41(3): 128-131, 142.
[13]叶明峰, 吴光亮. 优化精炼渣去除50Cr5MoV钢中Al₂O₃夹杂物的实验室研究[J]. 钢铁研究, 2017, 45(2): 19-23.
Ye Mingfeng, Wu Guangliang. Laboratory study on reducing Al₂O₃ inclusions in 50Cr5MoV steel by optimized refining slag[J]. Research on Iron and Steel, 2017, 45(2): 19-23.
[14]Doan D Q, Fang T H, Chen T H, et al. Effects of void and inclusion sizes on mechanical response and failure mechanism of AlCrCuFeNi₂ high-entropy alloy[J]. Engineering Fracture Mechanics, 2021, 252: 107848.
[15]马潇, 岑耀东, 陈林, 等. 淬火工艺对U75V重轨钢组织及力学性能的影响[J]. 金属热处理, 2020, 45(12): 59-62.
Ma Xiao, Cen Yaodong, Chen Lin, et al. Effect of quenching process on microstructure and mechanical properties of U75V heavy rail steel[J]. Heat Treatment of Metals, 2020, 45(12): 59-62.
[16]秦成, 车朝杰, 程丽任, 等. 铸态Mg-Sm-Gd-Zn-Zr合金微观组织与力学性能研究[J]. 中国稀土学报, 2021, 39(3): 523-530.
Qin Cheng, Che Chaojie, Cheng Liren, et al. Microstructure and mechanical properties of as-cast Mg-Sm-Gd-Zn-Zr alloy[J]. Journal of the Chinese Rare Earth Society, 2021, 39(3): 523-530.
[17]马胜宾, 滕敦波, 王俊翔. 热处理工艺对高C-Cr高强耐磨钢组织和性能的影响[J]. 中国冶金, 2021, 31(6): 39-44.
Ma Shengbin, Teng Dunbo, Wang Junxiang. Effect of heat treatment process on microstructure and properties of high C-Cr high strength wear resistant steel[J]. China Metallurgy, 2021, 31(6): 39-44.
[18]陈琳, 达木仁扎布, 王永明, 等. U76CrRE钢轨在线热处理工艺研究[J]. 包钢科技, 2021, 47(2): 1-5.
Chen Lin, Renzhabu Damu, Wang Yongming, et al. Study on line heat treatment process of U76CrRE rail[J]. Science and Technology of Baotou Steel, 2021, 47(2): 1-5.
[19]王军平, 周宇, 沈钢. 钢轨硬度对疲劳裂纹萌生和钢轨磨耗的影响[J]. 西南交通大学学报, 2021, 56(3): 611-618.
Wang Junping, Zhou Yu, Shen Gang. Effect of rail hardness on fatigue crack initiation and rail wear[J]. Journal of Southwest Jiaotong University, 2021, 56(3): 611-618.