等温处理对挤压态AZ80A镁合金半固态组织的影响

doi:10.13251/j.issn.0254-6051.2021.10.007

金属热处理 ›› 2021, Vol. 46 ›› Issue (10): 39-44.DOI: 10.13251/j.issn.0254-6051.2021.10.007

等温处理对挤压态AZ80A镁合金半固态组织的影响

段兴旺, 李鹏, 李凯

太原科技大学材料科学与工程学院, 山西太原 030024

收稿日期:2021-04-11 出版日期:2021-10-25 发布日期:2021-12-08
作者简介:段兴旺(1973—),男,副教授,博士,主要研究方向为大型锻造理论及新技术、镁合金塑性加工技术,E-mail:tykddxw@tyust.edu.cn

Effect of isothermal treatment on semi-solid microstructure of extruded AZ80A magnesium alloy

Duan Xingwang, Li Peng, Li Kai

School of Materials Science and Engineering, Taiyuan University of Science and Technology, Taiyuan Shanxi 030024, China

Received:2021-04-11 Online:2021-10-25 Published:2021-12-08

摘要/Abstract

摘要： 采用应变诱发熔化激活法(SIMA)工艺制备了AZ80A镁合金半固态坯料,研究了保温温度和保温时间对半固态组织的影响。结果表明:随着保温温度的升高和保温时间的增加,AZ80A镁合金的平均晶粒尺寸与液相率都呈上升趋势,形状因子呈先增大后减小的趋势。半固态组织由α-Mg晶粒、Al、Zn元素富集形成的晶界处液相和晶内“小液池”组成,其组织演变分为初始晶粒合并长大,晶粒球化、彼此分离,最终合并粗化3个阶段。采用该种方法制备AZ80A镁合金半固态坯料时合适的保温温度为550 ℃、保温时间为45 min,此时半固态组织的平均晶粒尺寸、形状因子和液相率分别为89 μm、0.795和26.7%。

关键词: AZ80A镁合金, 半固态组织, 保温温度, 保温时间, 组织演变。

Abstract: AZ80A magnesium alloy semisolid billet was prepared by strain induced melting activation (SIMA) method, and the effects of holding temperature and holding time on the semi-solid microstructure were studied. The results show that the average grain size and liquid fraction of the AZ80A magnesium alloy increase with the increase of the holding temperature and holding time, and the shape factor increases first and then decreases. The semi-solid microstructure is composed of α-Mg grains, liquid phase at grain boundary and intragranular “small liquid pools” formed by the enrichment of Al and Zn elements. The microstructure evolution can be divided into three stages: initial grain growth, grain spheroidization and separation, and finally grain coarsening. When using the SIMA method to prepare semi-solid AZ80A magnesium alloy, the suitable holding temperature is 550 ℃ and the holding time is 45 min, by which the average grain size, shape factor and liquid fraction of the semi-solid microstructure are 89 μm, 0.795 and 26.7%, respectively.

Key words: AZ80A magnesium alloy, semi-solid microstructure, holding temperature, holding time, microstructure evolution

中图分类号:

TG146.22

段兴旺, 李鹏, 李凯. 等温处理对挤压态AZ80A镁合金半固态组织的影响[J]. 金属热处理, 2021, 46(10): 39-44.

Duan Xingwang, Li Peng, Li Kai. Effect of isothermal treatment on semi-solid microstructure of extruded AZ80A magnesium alloy[J]. Heat Treatment of Metals, 2021, 46(10): 39-44.

参考文献

[1]杨淼, 刘耀辉, 张志义, 等. 热挤压对AM50镁合金组织及力学性能的影响[J]. 金属热处理, 2015, 40(12): 114-116.
Yang Miao, Liu Yaohui, Zhang Zhiyi, et al. Influence of hot-extrusion on microstructure and mechanical properties of AM50 magnesium alloy[J]. Heat Treatment of Metals, 2015, 40(12): 114-116.
[2]孙兵, 张英波, 权高峰, 等. AZ80镁合金半固态组织的等温演化研究[J]. 特种铸造及有色合金, 2014, 34(9): 928-932.
Sun Bing, Zhang Yingbo, Quan Gaofeng, et al. Microstructures evolution of semi-continuous cast and extruded AZ80 magnesium alloy with semi-solid isothermal treatment[J]. Special Casting and Nonferrous Alloys, 2014, 34(9): 928-932.
[3]Duan X W, Liu J J, Liu L L, et al. Study on constitutive model and dynamic recrystallization softening behavior of AZ80A magnesium alloy[J]. Materials Research Express, 2019, 6(12): 126576.
[4]Fan L, Zhou M, Zhang Y, et al. The semi-solid microstructural evolution and coarsening kinetics of AZ80-0.2Y-0.15Ca magnesium alloy[J]. Materials Characterization, 2019, 154: 116-126.
[5]Hu X G, Zhu Q, Lu H X, et al. Microstructural evolution and thixoformability of semi-solid aluminum 319s alloy during re-melting[J]. Journal of Alloys and Compounds, 2015, 649: 204-210.
[6]Xiao G, Jiang J, Liu Y, et al. Recrystallization and microstructure evolution of hot extruded 7075 aluminum alloy during semi-solid isothermal treatment[J]. Materials Characterization, 2019, 156: 109874.
[7]Tang Qi, Sun Hao, Zhou Mingyang, et al. Effect of Y addition on the semi-solid microstructure evolution and the coarsening kinetics of SIMA AZ80 magnesium alloy[J]. Metals, 2017, 7(10): 416.
[8]黄晓锋, 张乔乔, 马亚杰, 等. Mg-6Zn-1Cu-0.3Mn镁合金的半固态组织演变[J]. 材料导报, 2019, 33(20): 3441-3447.
Huang Xiaofeng, Zhang Qiaoqiao, Ma Yajie, et al. Semi-solid microstructure evolution of Mg-6Zn-1Cu-0.3Mn magnesium alloy[J]. Materials Reports, 2019, 33(20): 3441-3447.
[9]Tao J, Ji X, Zhang Y, et al. Microstructure evolution of Mg-Gd-Y-Zn-Zr magnesium alloy during partial remelting[J]. Materials Science, 2014, 20(4): 436-439.
[10]黄晓锋, 马亚杰, 张玉, 等. 等温热处理对ZC61-0.3Cr镁合金半固态组织演变的影响[J]. 中国有色金属学报, 2018, 28(10): 1962-1971.
Huang Xiaofeng, Ma Yajie, Zhang Yu, et al. Effects of isothermal heat treatment on microstructural evolution ZC61-0.3Cr magnesium alloy[J]. The Chinese Journal of Nonferrous Metals, 2018, 28(10): 1962-1971.
[11]Zhao Gaozhan, Yang Lin, Duan Xunxing, et al. Microstructure evolution and mechanical properties of AZ80 alloy reheated from as-cast and deformed state[J]. Transactions of Nonferrous Metals Society of China, 2012, 22(S2): 450-456.

[1]	陈建文, 袁伍丰, 蒋亦舟, 张晨, 易华清, 高毅强. 锻造加热温度对20Cr2Ni4A钢奥氏体晶粒长大及力学性能的影响[J]. 金属热处理, 2022, 47(2): 112-118.
[2]	马玉霞, 党淑娥, 陈慧琴. 固溶处理对Cu-Cr-Zr合金组织与性能的影响[J]. 金属热处理, 2022, 47(1): 163-166.
[3]	丁浩晨, 赵艳君, 苏原明, 王谢, 南权晖, 仇诚, 冯奕洁. 超快速加热退火下保温时间对5083铝合金组织及力学性能的影响[J]. 金属热处理, 2021, 46(4): 70-76.
[4]	晋家春, 邓宗吉, 杨峥, 李子涛, 卢茜倩, 崔磊, 刘永刚, 詹华. 加热工艺对1800 MPa级热成形钢冷弯性能的影响[J]. 金属热处理, 2021, 46(4): 126-130.
[5]	胡生双, 史利利, 何坤, 赵刚, 王清, 王文博, 王亚星. 回火保温时间对A-100钢力学性能和组织的影响[J]. 金属热处理, 2021, 46(2): 140-143.
[6]	杜晓洁, 何宜柱. E690钢奥氏体化过程的内耗分析[J]. 金属热处理, 2020, 45(8): 12-16.
[7]	刘豪, 张立文, 李飞, 张驰, 毛培刚, 李超群. 38CrMoAl钢的奥氏体晶粒长大行为[J]. 金属热处理, 2020, 45(8): 38-42.
[8]	周刘涛, 潘红波, 潘烁, 吴结文. 微碳低合金深冲双相钢的再结晶规律[J]. 金属热处理, 2020, 45(4): 45-50.
[9]	江海洋, 孙明月, 吴铭方, 乔岩欣. 7075铝合金热变形连接接头的组织与性能[J]. 金属热处理, 2020, 45(2): 46-50.
[10]	康华伟. 热镀锌结构钢带S550GD+Z的连退模拟试验[J]. 金属热处理, 2020, 45(11): 154-156.
[11]	高彩茹, 霍喜伟, 宋玉卿, 杜林秀, 乔鹏, 屈兵兵. 500 MPa级门架型钢的奥氏体晶粒长大行为[J]. 金属热处理, 2020, 45(1): 139-142.
[12]	张　俊1，徐增勇1，张太超2，贾广辉1，罗　斌3. 热处理对新能源汽车用稀土储氢合金电化学性能的影响[J]. 金属热处理, 2019, 44(1): 49-53.
[13]	陈连生，徐静辉，田亚强，郑小平，宋进英，米振鹏. Fe-C-Mn-Cu钢I&Q处理中Cu元素的配分行为[J]. 金属热处理, 2016, 41(7): 107-111.
[14]	胡海洋，胡昕明，王储，孙殿东，李广龙，欧阳鑫. 正火保温时间对P460NH钢板组织和性能的影响[J]. 金属热处理, 2016, 41(7): 127-130.
[15]	王立新1，智建国2，李智丽2，彭军1. 终冷温度和保温时间对U75V钢组织及硬度的影响[J]. 金属热处理, 2016, 41(5): 120-123.

等温处理对挤压态AZ80A镁合金半固态组织的影响

Effect of isothermal treatment on semi-solid microstructure of extruded AZ80A magnesium alloy

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 15

编辑推荐

Metrics

本文评价